WHEELTRONIC LIFT, AMMCO LIFT, and BEN PEARSON Rubber Contact Pads for 2 Post Automotive lift Heavy Duty Set of 4 complete with hardware. Used on AMMCO Lifts Ben Pearson Lifts Challenger Lifts Weaver Lifts WHEELTRONIC LIFTS
Product made in Canada Included in kit. 4 Rectangle shaped pads 4 3/8 mounting bolts washers and nuts.
Safety note: It is very important to have rubber contact vehicle frame in order to properly secure and lift vehicle safely. Steel contact to frame of vehicle can cause vehicle to slip off especially if vehicle in improperly spotted.
MOUNTING INSTRUCTION: Remove old hardware and pads from adaptor. If the hardware is seized place adaptor into a bench vise to secure adaptor. Once the adaptor is properly secured use a hand grinder and grind off the seized hardware. Please make sure your using proper safety glasses or shield before grinding. Clean the surface of the adaptor using a soft grinding disk to eliminate any sharp edges that can damage pad and effect its durability. Install new pad with counter sunk holes facing up to make contact to vehicle pick up points. Install hardware with bolt head on top surface and fasten with 3/8 nuts and washers supplied. Bolt inserted from top of pad and the nut is on the under side of adaptor, Torque the nut down until tight. repeat these steps 3 more times and your installation is complete. Your lifting equipment is ready to be safely used.
PAD MAINTENANCE TIP: Keeping your lift pads clean at all times will extend the Life of the pad. Once the vehicle has been removed and before loading another a quick wipe will keep oils and other chemical from deteriorating rubber material.